ANLEY Universal Car Hitch Mount Flagpole Holder -Vehicle Rear Flag Pole Mounting Bracket

Anley Universal Car Hitch Mount Flagpole Holder. Compatible with Standard 2 Inch Hitch Receiver for Truck, Jeep, Van & RV. Vehicle Rear Flag Pole Mounting Bracket – Fit Flagpole of 1 to 2 in.

• UNIVERSAL COMPATIBILITY – Compatible for any vehicle with a standard 2 inch hitch receiver. As to flagpoles, It widely suits to all poles with diameter of 1 to 2 inch.
• ADJUSTABLE LENGTH – When sliding into the hitch receiver, there are two notches at the mount, giving either 8.5″ or 11.5″ usable length. Works great for those vehicles even with spare tire on the back!
• INSTALL WITH BARE HANDS – NO tools required! Just slide the holder base into the hitch receiver and lock it in place with a locking pin. Then insert the falgpole and twist the two knobs to secure the pole.
• MORE STEAY, MORE SECURE – Two tightening screws will better secure the flagpole and stop the pole from wiggling during driving. A special drain-off bottom design allows rain and snow to fall through the holder instead of leading to rust.
• Installation Step 2 – Leave outdoors where the sun is fully unobstructed during the day.
• Installation Step 3 – After the day charge, press the switch into “On” – This will turn on the auto-on function.
• Installation Step 4 – Remove the previous ornament from the top of the flagpole.
• Installation Step 5 – Install Anley solar Led flagpole light and it will light up automatically at night